Start
As soon as you open NstLabelEditor, you will see a welcome
dialog box. Usually you can close it. Special occasions to look at it
are: registration and trouble shooting support.
Sart up wizard
As you close the welcome dialog box you will see a start-up wizard.
Usually it is divided in four areas:
- left side: two buttons permits you to work immediately with display mesures and label:
- the New cuts dimensions button lets you immeditely input the dimension of the display you are going to cut
- the New label button lets you immeditely start drawing the label layout
- center part: where you can select to work with a recent(if there were) job file
-
right side: where the open button lets you open a job file not included in the recent list and to work with it
- bottom area: where you can decide close the wizard without doing anything (Close button) and where you can select the:Show "Startup wizard ..." after launching if you want the wizard to open the next time you start NstLabelEditor.
If you had unselect Show "Startup wizard ..." after launching and the want start up Wizard to open again use the help menu to open it.